Canon iPF6400 Manuel

Page de 966
Configuring the Communication Mode Manually
Configuring the Communication Mode Manually
This topic gives instructions for configuring the communication mode manually.
1
 
On the Tab Selection screen of the Control Panel, press 
◀ or ▶ to se-
lect the Settings/Adj. tab (
).
Note
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press  or  to select Interface Setup, and then press the OK button.
4
Press  or  to select Ethernet Driver, and then press the OK button.
5
Press  or  to select Auto Detect, and then press the OK button.
6
Press  or  to select Off, and then press the OK button.
The display reverts to the Ethernet Driver menu.
7
Press  or  to select Comm.Mode, and then press the OK button.
8
Press  or  to select the communication mode, and then press the OK button.
The display reverts to the Ethernet Driver menu.
9
Press  or  to select Ethernet Type, and then press the OK button.
10
Press  or  to select the Ethernet type, and then press the OK button.
The display reverts to the Ethernet Driver menu.
11
Press  or  to select Spanning Tree, and then press the OK button.
12
Press  or  to enable or disable spanning tree support, and then press the OK button.
The display reverts to the Ethernet Driver menu.
13
 
Press the Menu button.
After the confirmation message is displayed, press the OK
button.
The new settings will take effect after the printer restarts.
Note
Communication can also be configured on the Network page in RemoteUI.
 
 
iPF6400
                                                                                                                                                             
Configuring the Communication Mode Manually
 
 
Network Setting
Other Settings
701