Canon iPF6400 Manuel
Cause
Corrective Action
A cut line is printed because CutDustRe-
duct. is On in the Control Panel menu to re-
duce cutting dust.
duct. is On in the Control Panel menu to re-
duce cutting dust.
If this function is not needed, set CutDustReduct. to Off in the Control Panel menu.
The Printhead is set too low in the Control
Panel menu.
Panel menu.
In the Control Panel menu, set Head Height to Automatic.
You are printing on heavyweight paper or pa-
per that curls or wrinkles easily after absorb-
ing ink.
per that curls or wrinkles easily after absorb-
ing ink.
When printing on Canon Heavyweight Coated Paper or other paper-based media, choose a
VacuumStrngth setting of Strong or Strongest in the Control Panel menu. If rubbing still oc-
curs, in the Control Panel menu, use a higher Head Height setting.
VacuumStrngth setting of Strong or Strongest in the Control Panel menu. If rubbing still oc-
curs, in the Control Panel menu, use a higher Head Height setting.
When printing on CAD Tracing Paper or other film-based media, choose a VacuumStrngth
setting of Standard, Strong, or Strongest in the Control Panel menu. If rubbing still occurs, in
the Control Panel menu, use a higher Head Height setting.
setting of Standard, Strong, or Strongest in the Control Panel menu. If rubbing still occurs, in
the Control Panel menu, use a higher Head Height setting.
The Ejection Guide is soiled.
Clean the Ejection Guide.
The surface of the paper is dirty
The surface of the paper is dirty
Cause
Corrective Action
The Paper Retainer is soiled.
Clean the Paper Retainer.
You are using a paper that does not
dry easily.
dry easily.
In the Control Panel menu, set Roll DryingTime to at least 1 min.
When paper that does not dry easily is used for printing, it may curl during printing and touch the Output
Tray.
In this case, in the Control Panel menu, complete the settings for Dry time and Area in Scan Wait
Time.
However, note that printing will now take longer.
Tray.
In this case, in the Control Panel menu, complete the settings for Dry time and Area in Scan Wait
Time.
However, note that printing will now take longer.
The back side of the paper is dirty
The back side of the paper is dirty
Cause
Corrective Action
The Platen has become dirty after borderless printing or printing on small pa-
per.
per.
Open the Top Cover and clean the Platen.
The Platen suction is too strong.
In the Control Panel menu, reduce the level of VacuumStrngth.
BordlessOversize is set to Standard in the Control Panel menu.
Set BordlessOversize to Little in the Control Panel menu.
Roller marks are left across the trailing edge of paper
Roller marks are left across the trailing edge of paper
Cause
Corrective Action
The paper was removed without pressing the OK button after
printing from the Front Paper Feed Slot.
printing from the Front Paper Feed Slot.
Following the instructions displayed, press the OK button, and after remov-
ing the paper, press the OK button again.
ing the paper, press the OK button again.
Wipe the rollers to clean them.
iPF6400
The surface of the paper is dirty
Troubleshooting
Problems with the printing quality
893