Canon iPF9400 Manuel

 

Close the Top Cover.

Once paper feeding starts, you will need to do the following, based on the ManageRemainRoll setting and the
barcode printed on rolls. 

Barcodes

Printer Operation After the Paper is Fed

Printed

A menu for selection of the type of paper is shown on the Display Screen.
Press ▲ or ▼ to select the type of paper, and then press the OK button.

Not printed

Printed

The type and amount of paper left is automatically detected based on the barcode printed on the roll.
There is no need to specify the type and length of the paper.

Not printed A menu for selection of the type and length of paper is shown on the Display Screen.

Press ▲ or ▼ to select the type and length of paper loaded, and then press the OK button.

Important

Cut the edge of the roll using the Paper Cutting function if the edge is creased or soiled. 

Note

For details on types of paper to select, see the Paper Reference Guide. 

Adjusting the printhead alignment with the type of paper to be used in printing may enhance printing quality. 

When paper leading edge detection is set to Off for Manual, printing will start at the position at which the roll was set
in procedure 8. Thus, the margin of the paper leading edge will enlarge. 

Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of con-
figuring the media type setting when you load the paper again. The current media type settings before you select On
will be automatically selected at that time. 

Important

For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper. Be sure to
select the type of paper to use correctly before printing.

Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed images may vary
depending on the type of paper used. If margins and the size of images are not as you expected, adjust the paper feed
amount.

Rolls and sheets have different printing areas, and sheets having a larger bottom margin than rolls.

 

iPF9400

                                                                                                                                                                                                

Changing the Type of Paper

                                                                                                                                                                                                                                        

Handling and Use of Paper

Handling rolls

537