LXE vx3x Guide De Référence
Summit Radio
179
E-EQ-VX3XRG-D
VX3X Reference Guide
LEAP without WPA Authentication
To use LEAP (without WPA) make sure the following profile options are used:
• Enter the SSID of the Access Point assigned to this profile
• Set EAP Type to LEAP
• Set Encryption to Auto WEP
• Set Auth Type as follows:
• Set EAP Type to LEAP
• Set Encryption to Auto WEP
• Set Auth Type as follows:
o
If the Cisco/CCX certified AP is configured for open authentication, set the
Auth Type radio parameter to Open.
o
If the AP is configured for network EAP only, set the Auth Type radio
parameter to LEAP.
Please see “WPA/LEAP” later in this section to configure the radio for WPA LEAP.
Figure 5-15 LEAP Configuration
Please review “Sign-On vs. Stored Credentials”, earlier in this chapter.