Jura impressa e8 Mode D'Emploi

5.Push the Rinse button. The display shows

.

After a moment the display shows

.

6.Open the ground coffee lid and drop in one white cleaning

tablet (Fig. 22). Your machine comes with a pack of two 
tablets. To order more tablets see chapter 22 "Supplies".

7.Push the Rinse button. The display shows 

.

The cleaning program will dispense hot foamy water in 
intervals through the coffee spout into the drawer.

8.When finished, the display shows 

.

9.Lift and remove the drawer. Empty the used coffee container

and drawer and replace. The display shows 

indicating 

the machine is now ready to brew coffee again.

Attention: You can run a tablet cleaning cycle at anytime even if
the machine does not prompt you,
•

. Push and hold the Rinse button until display shows 

. The Dial illuminates.

• Turn the Dial until display shows 

. Push the Dial.

Display shows 

.

• Continue with step 3 above.

20c. DECALCIFYING PROCEDURE
The machine has an integrated decalcifying program. When the
display shows 

it is

time to decalcify the machine. You can still make coffee.
However, it is highly recommended that you decalcify the machine
within the next 3 to 4 days.
Please note: If you use the Clearyl water cartridge and the
display shows 

, then

your cartridge function is not activated. Follow the instructions in

chapter 16a to program the Clearyl Cartridge function.
Important: The decalcifying program must not be interrupted.

DECALCIFYING AGENT: Only use our special decalcifying
tablets. For supplies see chapter 22.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
1. Push the Rinse button. The display shows 

.

2. Remove and empty the drawer and used coffee container 

and replace complete assembly (Fig. 21).
Important: Even if the drawer and the used coffee container 
are empty, you still need to remove the tray for approx. 20 
seconds and then replace it. The display shows 

.

3. Make sure the water tank is empty. Completely dissolve three

of the large square tablets in 16 oz. of water and pour this 
mixture into the water tank.

4. Replace water tank. Place a large container (at least 20 oz.) 

underneath the frother.

5. The displays shows 

. Turn the

Steam/Water Selector to the water symbol. The machine will 
pump the mixture through the frother in intervals. During this 
procedure the display shows 

. When this cycle is 

finished the display shows 

.

6. Turn the Steam/Water Selector back to the cup symbol.

The display shows 

. Now the machine pumps the

mixture through the coffee spout into the drawer.

7. When this cycle is completed the display shows 

. Remove the container from underneath the 

frother. Carefully lift and remove the drawer, empty and 

21.