Excalibur fx202 Mode D’Emploi

7

3. Press the DIRECTIONAL 
KEY PAD again to locate the 
desired base.
4. Press the A key to throw the 
ball to that base.

PITCHER SELECT: Indicates
that you are pitching and asks 
you to select a pitch location.
BATTER SELECT: Indicates 
that you are batting and to 
select a pitch location.
HIT: occurs when the batter hits 
the ball.
SAFE: the ball falls on the fi eld 
and the batter successfully runs 
to the base.
OUT: the batter is out.
STRIKE: occurs when the batter 
misses a pitch or lets a pitch go 
by within the strike zone.
BALL: the batter lets a pitch go 
by outside of the strike zone.
FOUL: the ball falls outside of 
the designated fi eld area.
HOME RUN: the batter hits 
the ball over the outfi eld fence 
within the designated fi eld area. 

DEAD BALL: occurs when the 
batter is hit by a pitch.
TAKE ONE BASE: occurs 
when a batter is hit by the 
pitch, or when 4 BALLS are 
accumulated. 
FLY

LL: a ball caught in mid air.

TEAM REPLACE: teams 
exchange positions after each 
half inning.

half

half
NOTE: The umpire gives hand 
signals for STRIKE, OUT, 
SAFE, and HOME RUN.

• Each inning has two halves. 
• Each half ends when the batter  
  has 3 outs, or when a team  
  scores 39 runs.
• One run is scored wihen a  
  base runner crosses home  
  plate.

1. Make sure both units are 
turned off.
2. Connect both units with the 
two-player connection cord. Be 
sure to insert the cord in the 
correct direction.
3. Press the ON/OFF key to turn 
the units on.
4. Press START on either of the 
two units to start the 2-player 
game.
5. Follow the directions for 1-
player mode from this point.