Haier CRDE200AW Manuel D’Utilisation
Dark and light colored clothes should be separately dried. Fabrics prone to
creating lint and those prone to accumulating lint should be separately
dried. Clothes prone to creating lint should be turned inside out before
putting into the dryer.
Make sure buttons and ornaments on the clothes are high temperature
resistant and won't damage drum surface. Before loading, the clothes
should have their zippers zipped up, buttons and hooks done up and belts
tied so as to avoid entanglement or other obstacles.
If possible, turn out the clothes pockets for uniform drying.
Check if clothes remain soiled. If yes, wash it away again, otherwise the soils
after drying may not be removed permanently.
Small articles should be collected in a mesh bag before loading and
drying to avoid entanglement and ensure that they can be found easily.
Make sure power socket is reliably grounded. The grounding terminal must
not be connected to gas or tap water pipelines.
Make sure exhaust duct has been connected with extension pipe.
Make sure lint filter is clean and then assemble it properly. If lint filter is not in
place, tumbling items could enter the exhaust system and cause damage
to the dryer.
creating lint and those prone to accumulating lint should be separately
dried. Clothes prone to creating lint should be turned inside out before
putting into the dryer.
Make sure buttons and ornaments on the clothes are high temperature
resistant and won't damage drum surface. Before loading, the clothes
should have their zippers zipped up, buttons and hooks done up and belts
tied so as to avoid entanglement or other obstacles.
If possible, turn out the clothes pockets for uniform drying.
Check if clothes remain soiled. If yes, wash it away again, otherwise the soils
after drying may not be removed permanently.
Small articles should be collected in a mesh bag before loading and
drying to avoid entanglement and ensure that they can be found easily.
Make sure power socket is reliably grounded. The grounding terminal must
not be connected to gas or tap water pipelines.
Make sure exhaust duct has been connected with extension pipe.
Make sure lint filter is clean and then assemble it properly. If lint filter is not in
place, tumbling items could enter the exhaust system and cause damage
to the dryer.
Notes: This applies to Auto Dry cycle and Timed Dr y cycle. For Rack Dry
cycle, remove the lint filter and assemble the drying rack with its rear end
slightly downward inclined. The assembled status is as shown in the following
figure:
cycle, remove the lint filter and assemble the drying rack with its rear end
slightly downward inclined. The assembled status is as shown in the following
figure: