Haier xqb50-18 Manuel D’Utilisation
The washing mashine away from wall should be overrun 20mm. The largest allowable slope of the shank base of
the machine is 2
the machine is 2
.The slanting or rough ground will result in unstable running or stoppage of the machine.
Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
<2
Adjust the Installation position
Screw
Back
Front
bottom plate
Soft object
Fasten
Loosen
High
Low
the adjustable nut
the adjustable feet
Install the bottom plate
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
Hand-wash type wash:
The inner tub and pulsator rotate to opposite
directions during washing to form current like the
hand-wash moving. At the same time the washing
effect is improved significantly because the wall of the
inner tub also acts in washing.
The inner tub and pulsator rotate to opposite
directions during washing to form current like the
hand-wash moving. At the same time the washing
effect is improved significantly because the wall of the
inner tub also acts in washing.
After opening the package, please lean the washing
machine gently down on soft items (like towel cloth,
blanket, etc.). Installthe bottom plate to the bottom of
the machine with eight screwsby a cross screwdriver,
then lift the machine up gently. See to the figure:
machine gently down on soft items (like towel cloth,
blanket, etc.). Installthe bottom plate to the bottom of
the machine with eight screwsby a cross screwdriver,
then lift the machine up gently. See to the figure:
Before Using
Special function
Installation and adjustment