Frigidaire fgf379wesr Manuel De Montage

Operation of electric igniters should be checked after range

and supply line connectors have been carefully checked for

leaks and range has been connected to electric power.

The oven burner is equipped with an electric control system

as well as an electric oven burner igniter. If your model is

equipped with a waist-high broil burner, it will also have an

electric burner igniter. These control systems require no

adjustment. When the oven is set to operate, current will

flow to the igniter. It will "glow" similar to a light bulb.

When the igniter has reached a temperature sufficient to

ignite gas, the electrically controlled oven valve will open

and flame will appear at the oven burner. There is a time

lapse from 30 to 60 seconds after the thermostat is turned

ON before the flame appears at the oven burner. When the

oven reaches the dial setting, the glowing igniter will go

off.  The burner flame will go "out" in 20 to 30 seconds after

the igniter goes "OFF." To maintain any given oven

temperature, this cycle will continue as long as the dial (or

display) is set to operate.

After removing all packing materials and literature from

the oven:

a) Set oven to BAKE at 300ºF. See Owner's Guide for

operating instructions.

b) Within 60 seconds the oven burner should ignite.

Check for proper flame, and allow the burner to cycle

once. Reset controls to off.

c) If your model is equipped with a waist-high broiler, set

oven to BROIL. See Owner's Guide for operating

instructions.

d) Within 60 seconds the broil burner should ignite.

Check for proper flame. Reset controls to off.

The approximate flame length of the oven burner is 1 inch

(distinct inner, blue flame).

To determine if the oven burner flame is proper, remove the

oven bottom and burner baffle and set the oven to bake at

300°F.

To remove the oven bottom, remove oven hold down

screws at rear of oven bottom. Pull up at rear, disengage

front of oven bottom from oven front frame, and pull the

oven bottom out of the oven. Remove burner baffle so that

the burner flame can be observed.

If the flame is yellow in color, increase air shutter opening

size. (See "2" in illustration below.) If the flame is a distinct

blue, reduce the air shutter opening size.

To adjust loosen lock screw (see "3" illustration below),

reposition air shutter, and tighten lock screw. Replace oven

bottom.

The approximate flame length of the broil burner is 1 inch

(distinct inner, blue flame).

To determine if the broil burner flame is proper, set the

oven to broil.

If the flame is yellow in color, increase air shutter opening

size. (See "2" in illustration above.) If the flame is a distinct

blue, reduce the air shutter opening size.

To adjust, loosen lock screw (see "3" in illustration above),

reposition air shutter, and tighten lock screw.