Nortel 2350 Mode D'Emploi
102 Configuring and managing ports and VLANs
NN47250-500 (320657-F Version 02.01)
To configure a port group named server1 containing ports 1 through 5 and enable the link, type the following command:
WSS
# set port-group name server1 1-5 mode on
success: change accepted.
After you configure a port group, you can use the port group name with commands that change Layer 2 configuration
parameters to apply configuration changes to all ports in the port group. For example, Spanning Tree Protocol (STP) and
VLAN membership changes affect the entire port group instead of individual ports. When you make Layer 2 configura-
tion changes, you can use a port group name in place of the port list. Ethernet port statistics continue to apply to
individual ports, not to port groups.
parameters to apply configuration changes to all ports in the port group. For example, Spanning Tree Protocol (STP) and
VLAN membership changes affect the entire port group instead of individual ports. When you make Layer 2 configura-
tion changes, you can use a port group name in place of the port list. Ethernet port statistics continue to apply to
individual ports, not to port groups.
To configure a port group named server2 containing ports 15 and 17 and add the ports to the default VLAN, type the
following commands:
following commands:
WSS# set port-group name server2 15,17 mode on
success: change accepted.
success: change accepted.
WSS# set vlan default port server2
success: change accepted.
success: change accepted.
To verify the configuration change, type the following command:
WSS# show vlan config
To indicate that the ports are configured as a port group, the show vlan config output lists the port group name instead of
the individual port numbers.
the individual port numbers.
Removing a port group
To remove a port group, use the following command:
clear port-group name name
Displaying port group information
To display port group information, use the following command:
show port-group [name group-name]
To display the configuration and status of port group server2, type the following command:
WSS# show port-group name server2
Port group: server2 is up
Ports: 15, 17
Port group: server2 is up
Ports: 15, 17
VLAN
Name
Admin VLAN
Tunl Port
Status State
Affin
Port Tag
State
1
default
Up
Up
5
server2
none
Up