Optoma DX606V Manuel D’Utilisation

3

English



When the lamp 

reaches the end 

of its life, the 

projector will 

not turn back on 

until the lamp 

module has 

been replaced. 

To replace the 

lamp, follow 

the procedures 

listed under 

“Replacing the 

Lamp” section 

on pages

 

47-48.

 Precautions

 

 

Warning-  Do not look into the projector’s lens when the lamp is 

on. The bright light may damage your eyes.

 

Warning-  To reduce the risk of fi re or electric shock, do not  

expose this projector to rain or moisture.

 

Warning-  Please do not open or disassemble the projector as 

this may cause electric shock.

 

Warning-  When replacing the lamp, please allow unit to cool 

down, and follow all replacement instructions. 

See pages 47-48.

 

Warning-  This projector will detect the life of the lamp itself. 

Please be sure to change the lamp when it shows 

warning messages.

 

 Warning-  Use the “Lamp Reset” function from the on-screen 

display “Options|Lamp Settings” menu after 

replacing the lamp module (refer to page 40).

 

Warning-  When switching the projector off, please ensure the 

cooling cycle has been completed before 

disconnecting the power. Allow 90 seconds for the 

projector to cool down. 

 

Warning-  Do not use the lens cap when projector is in opera-

tion.

 

Warning-  When the lamp is approaching to the end of its life, 

the message “Lamp Warning: Lamp life exceeded.” 

will show on the screen. Please contact your local 

reseller or service center to change the lamp as soon 

as possible.