Intermec 1470 Mode D'Emploi

The serial programming commands can be used in place of the programming bar codes
listed in Chapter 3. Both the serial commands and the programming bar codes will
program the imager. For complete descriptions and examples of each programming
command, refer to Chapter 3.

To enter a serial command, click in the Enter Menu Command text box and type in the
command(s) you wish to use. If you are typing in more than one command, separate the
commands with a semicolon (;). Click Send Command to send the command(s) to the
imager.

The imager responds to serial commands with one of three responses:

ACK

Indicates a good command that has been processed.

ENQ

Indicates a bad command.

NAK

Indicates the command was good, but the entry was out of the allowable range,
e.g., an entry for a minimum message length of 100 when the field will only
accept 2 characters.

Display All Settings    Displays the settings currently saved for the imager.

Display Setting Ranges    Displays all the possible serial commands and the allowable
data field parameters.

Display Firmware Rev    Displays the software version being used by the imager.