Marvel 6sbare-bb-o Mode D'Emploi
CARE AND CLEANING
Condenser
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that noth-
ing obstructs the required air flow openings in front of the
cabinet. At least once or twice a year, brush or vacuum lint
and dirt from the front grille area (see page 3).
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that noth-
ing obstructs the required air flow openings in front of the
cabinet. At least once or twice a year, brush or vacuum lint
and dirt from the front grille area (see page 3).
Cabinet
The stainless steel cabinet can be washed with either a
stainless steel cleaner or a mild soap and water and thor-
oughly rinsed with clear water. NEVER use abrasive scour-
ing cleaners. Painted surfaces can be cleaned with mild
soap and water.
The stainless steel cabinet can be washed with either a
stainless steel cleaner or a mild soap and water and thor-
oughly rinsed with clear water. NEVER use abrasive scour-
ing cleaners. Painted surfaces can be cleaned with mild
soap and water.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Shelves
The racks may be cleaned with mild soap and water and a
soft cloth. Do NOT use any abrasive cleaners. See below
for instructions for removing the shelves.
The racks may be cleaned with mild soap and water and a
soft cloth. Do NOT use any abrasive cleaners. See below
for instructions for removing the shelves.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
17
Removing the Wine Shelves.
Unload the shelf to be removed. Pull the shelf all the way
out until it stops. At the front of the drawer slide just under
the shelf there is a plastic block (see Figure 17). Push this
block to the rear to release the slide. Repeat on other side
of the shelf. Lift the front of the shelf and pull away from
the slides to remove the shelf.
Unload the shelf to be removed. Pull the shelf all the way
out until it stops. At the front of the drawer slide just under
the shelf there is a plastic block (see Figure 17). Push this
block to the rear to release the slide. Repeat on other side
of the shelf. Lift the front of the shelf and pull away from
the slides to remove the shelf.
Reverse this procedure to install the shelf. Be sure to move
the plastic block to the forward position after installing the
shelf.
the plastic block to the forward position after installing the
shelf.
Figure 17
Plastic Block on
bottom front of slide
bottom front of slide