Blomberg tkf 1230 Mode D'Emploi
Trouble Shooting
If you notice…
Appliance cannot be turned on
or program will not start
•
Program chosen? Button “Start/Pause" pressed?
Door properly closed?
Power cable plugged in?
Main fuse has blown in your home.
Door properly closed?
Power cable plugged in?
Main fuse has blown in your home.
•
•
•
•
•
Appliance does not react to input
•
Is the child lock active?
If fault persists: Unplug the appliance, wait a few
If fault persists: Unplug the appliance, wait a few
seconds, re-plug.
•
•
•
Anti-crease phase is running (2 hours).
• Switch off appliance, take out laundry.
Drum interior lighting does not
work (depending on model) .
•
Lamp faulty? Call customer service.
• Dry only textiles labeled suitable for tumble drying.
• Dry only with a program suitable for the particular
• Dry only with a program suitable for the particular
textile type.
The control lamp „Drying“ is
blinking during the program
•
Indicator “Clean filter” signals
during the program
during the program
•
Stop the program
Clean the fluff filter
Clean the fluff filter
If the problem continues: Switch off the appliance
and call costumer service.
and call costumer service.
•
•
•
Laundry is too wet or drying
time is too long
time is too long
•
Drum overloaded? See ,,Program table".
Make sure of good ventilation. Check vent slots.
Make sure of good ventilation. Check vent slots.
Clean fluff filter.
Clean drum ribs.
Finish dry with a suitable timed program.
Finish dry with a suitable timed program.
check…
Indicator “End/Anti-crease”
flashes, signal sounds
Program stops without apparent
reason
• Is the door open?
• Was there a blackout? Press the Start/Pause-Button.
• Was there a blackout? Press the Start/Pause-Button.
Textiles are shrunk, felted,
damaged
Switch off appliance, take out the laundry, call costumer
service
service
•
•
•
•
If you cannot solve the problem yourself contact our customer service.
Have the Model and Identification number as per rating label handy.