Panasonic vdr-m53 Mode D'Emploi

Page de 170
158
During recording
Symptom
Cause and Correction
Reference 
page
Pressing the REC button 
will not start recording.
Is input image copy-guarded?
Copy-guarded image cannot be recorded on this DVD Video 
Camera.
75
Recording starts but 
stops immediately.
Is disc scratched or do dirt or fingerprints adhere to it?
Clean the disc. If there is still no improvement, replace the disc.
30
If you turn this DVD Video Camera on for many hours in a high 
temperature location, this DVD Video Camera may automatically 
stop recording for the protection of the lens in the laser pickup 
assembly. In this case, follow the messages on the display of this 
DVD Video Camera.
To start recording again, turn this DVD Video Camera off and leave 
it for a while.
Is some other AV device directly connected to the AV input/output 
jack of this DVD Video Camera?
If the AV device is connected via several other devices, such as AV 
selector, the video signal may be transmitted incorrectly. In such a 
case, reduce the number of devices through which the video signal 
is transmitted, or connect AV device directly.
75
Are you attempting to record an image from a video game or PC?
From some video games or PCs, images cannot be recorded on this 
DVD Video Camera.
75
LCD screen is hard to 
see.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
91
Is the DVD Video Camera being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so that 
LCD screen is not exposed to direct sunlight.
38
Focus is not correct.
Is it difficult to use auto focus with your subject?
Focus manually.
65
Does “MF” appear?
The DVD Video Camera is set to manual focus. Focus the subject 
manually, or release manual focus.
64
Is the diopter control correctly adjusted if you are using the 
viewfinder as a monitor?
Adjust the diopter control.
37
In cases other than the above, set the power switch to “OFF”, and 
then set it to “
”, “
” or “
” again.
50
Some vibrations are felt 
or slight sound is heard 
from mechanism.
These vibrations or sound are caused by disc drive: This does not 
indicate a fault.
VDR-M95M75M55M53PP.book  Page 158  Tuesday, March 29, 2005  2:19 PM