Panasonic tc-l50et60 Mode D'Emploi

7

■

 

●

To use the built-in wireless LAN, using an access point is recommended.

 

●

To use the built-in wireless LAN in the access point mode, up to 7 devices are connectable. But the 
transfer rate will vary according to communication environment or connected equipments.

 

●

Do not use the built-in wireless LAN to connect to any wireless network (SSID*

1

) for which you do 

not have usage rights. Such networks may be listed as a result of searches. However, using them 
may be regarded as illegal access.

 

●

Check that the Access point supports WPS*

2

. 

(If it does not support WPS, the encryption key of the Access point is required when configuring 
settings.)

 

●

Follow the instructions on the Access point setup screen and configure the appropriate security 
settings.
For more details on setting of Access point, please refer to operating manual for the Access point.

 

●

We recommend using 11n (5 GHz) for the wireless system between the built-in wireless LAN and 
Access point.
Communication is also possible with 11a, 11b, and 11g, but the communication speed may be slower.

 

●

If the wireless system of the Access point is changed, devices that could connect by wireless LAN 
may no longer be able to connect.

 

●

Data transmitted and received over radio waves may be intercepted and monitored.

 

●

Keep the TV away from the following devices as much as possible:
Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the 
TV failures such as malfunction may occur due to the radio wave interference.

 

●

When noises occur due to the static electricity, etc., the TV might stop operating for the protection 
of the devices. In this case, turn the TV Off with power On / Off switch, then turn it On again.

*

1

 SSID is a name for identifying a particular wireless network for transmission.

*

2

 WPS: Wi-Fi Protected Setup

Flat panel displays are not always supported on 

the proper stands or installed according to the 

manufacturer’s recommendations. Flat panel 

displays that are inappropriately situated on 

dressers, bookcases, shelves, desks, speakers, 

chests, or carts may fall over and may cause 

personal injury or even death. 

The consumer electronics industry (of which 

Panasonic is a member) is committed to making 

home entertainment enjoyable and safe. To prevent 

personal injury or death, be sure to follow the 

following safety guidelines: 

•  One size does NOT fit all.  Follow the 

manufacturer’s recommendations for the safe 

installation and use of your flat panel display. 

•  Carefully read and understand all enclosed 

instructions for proper use of this product. 

•  Don’t allow children to climb on or play with 

furniture and television sets. 

•  Don’t place flat panel displays on furniture that 

can easily be used as steps, such as a chest of 

drawers. 

•  Remember that children can become excited while 

watching a program, especially on “larger than life”  

flat panel displays.  Care should be taken to install 

the display where it cannot be pushed, pulled over, 

or knocked down. 

•  Care should be taken to route all cords and cables 

connected to the flat panel display so that they 

cannot be pulled or grabbed by curious children. 

WALL MOUNTING: IF YOU DECIDE TO WALL 

MOUNT YOUR FLAT PANEL DISPLAY, ALWAYS: 

•  Use a mount that has been recommended by 

the display manufacturer and/or listed by an 

independent  laboratory (such as UL, CSA, ETL). 

•  Follow all instructions supplied by the display and 

wall mount manufacturers. 

•  If you have any doubts about your ability to safely 

install your flat panel display, contact your retailer 

about professional installation. 

•  Make sure the wall where you are mounting the 

display is appropriate.  Some wall mounts are not 

designed to be mounted to walls with steel studs 

or old cinder block construction.  If you are unsure, 

contact a professional installer. 

•  A minimum of two people are required for 

installation.  Flat panel displays can be heavy.