Panasonic DBS 576 Manuel Complémentaire
Section 700 - Operation
Chapter 7. SLT Features
576-50-700
DBS 576HD (USA) issued September 2001
5-47
To check a programmed FF key (Display Phone Only):
Hardware Requirements
•
N/A
Related Programming
•
FF1-2: Dial Plan
•
FF3: Extension Numbers
•
FF4: FF Key Assignment
Considerations
•
If a new code is programmed into a key, the previously programmed code is erased.
•
FF keys assigned as CO lines must be cleared using system programming before new FF
assignments can be made.
•
The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
•
The ANSWER key functions as listed in the table below.
•
The RELEASE key functions as listed in the table below.
Action
Result
1. Lift the handset or press the ON/OFF key.
Intercom dial tone
2. Press the CONF key.
C displays
3. Press the FF key to be checked.
Programmed data displays
4. Replace the handset or press the ON/OFF key.
Status
Condition
Operation when ANSWER key is pressed
Idle
No incoming ring
Ignore.
Incoming ring
Monitor ON (speaker) - Auto Answer for incom-
ing ring.
ing ring.
Off-Hook
Off-hook signaling
Answer for off-hook signaling. Current conver-
sation will be put on hold automatically.
sation will be put on hold automatically.
No off-hook signaling
Ignore.
Note: When the extension has 1 non-appearing CO on hold and 1 non-appearing CO at talk,
ANSWER key operation is ignored and you can’t put the 2nd non-appearing CO on hold.
ANSWER key operation is ignored and you can’t put the 2nd non-appearing CO on hold.
Status
Condition
Operation when RELEASE key is pressed
Idle
--
Ignore.
Monitor ON
(speaker) or Headset
Mode
(speaker) or Headset
Mode
Several held calls
Latest held call will be transferred; phone returns
to idle status (Monitor OFF).
to idle status (Monitor OFF).
No held calls
Current call (talk) will be released; phone returns
to idle status (Monitor OFF).
to idle status (Monitor OFF).