Panasonic KX-UT113 Mode D'Emploi

•

The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near
the unit and is easily accessible.

•

Ensure that the headset cord has slack and is not pulled tight during use to prevent damage to the
connectors.

•

Cords used to connect devices to the EHS jack or headset jack must be less than 3 m (9.8 ft) in
length.

•

It is recommended that you use one of the following headsets:

–

Wired headsets
Panasonic KX-TCA400 or KX-TCA430

–

EHS headsets (KX-UT133/KX-UT136 only)
Plantronics

®

 Savi

®

 Talk, Voyager™, or CS series

•

Use flexible, high-quality, snagless (without strain relief) cables. Do not use cables with coating
that may tear or crack when bent.
To prevent damage to the cables, use cables that do not protrude from the bottom of the base.
Connect the cables as shown in the following illustration.

Ethernet cable

Ethernet cable

60 mm (2 

3

/

8

 in) 

or less

•

Use a straight CAT 5 (or higher) Ethernet cable (not included) that is 6.5 mm (

1

/

4

 in) in diameter or

less.

•

If PoE is available, an AC adaptor is not needed.

•

This unit complies with the PoE Class 2 standard.

•

Only a PC can be connected to the PC port. Other SIP phones, or network devices such as routers
or switching hubs, cannot be connected.

•

The PC port does not support PoE for connected devices.

•

Ensure that the Ethernet cables and the AC adaptor cord are clamped to prevent damage to the
connectors.

Document Version  2011-09  

Operating Instructions

61