Incra 3000 Mode D'Emploi

2

Remove the hex bolt that secures the protractor head
and replace with the large threaded knob included in the
hardware pack. The washer on the hex bolt must be

used with the threaded knob,  Fig. 1.

The method used to join the fence mounting bracket to

the protractor head makes it easy to fine-tune the fence

perfectly perpendicular to your tabletop. To adjust,

loosen the (3) #10-24 socket head screws that secure

the bracket and slide a paper or plastic shim between

the bracket and the protractor head. Placing the shim

behind the screws will decrease the angle. Placing the

shim in front of the screws will increase the angle.

Place the INCRA Miter 3000 in the left-hand miter slot
of your table saw. Loosen the (2) 

1

⁄

4

-20 socket head

screws that secure the fence to the fence mounting

bracket and slide the fence to a position that leaves safe
clearance between the end of the fence and the blade. Tighten
the (2) 

1

⁄

4

- 20 fasteners,  Fig. 3.

If the miter slot in your table saw has a T-slot, attach the T-clip to
the end of the miter bar as shown in  Fig. 2.