Sony mex-bt5700u Mode D'Emploi
24
Notes
• While connecting to a Bluetooth device, this unit
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, disconnect the current connection and
search for this unit from another device.
detection, disconnect the current connection and
search for this unit from another device.
• Depending on the device, searching from this unit
may not be possible. In this case, search for this unit
from the connecting device.
from the connecting device.
• If you search for this unit and the connecting device
mutually at the same time, this unit will not recognize
the connecting device.
the connecting device.
• It may take time to search or connect.
• Depending on the device, the confirmation display of
• Depending on the device, the confirmation display of
the connection appears before inputting the
passcode.
passcode.
• The time limit for inputting the passcode differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
About Bluetooth icons
The following icons are used by this unit.
* Turns gray without handsfree connection. Differs in
the case of a cellular phone.
Connection
If pairing has already been achieved, start
operation from here.
operation from here.
Connecting a cellular phone
1
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using the cellular
phone.
“
phone.
“
”appears when the connection is made.
Connecting to registered devices
1
Press (BT).
The Bluetooth settings menu appears.
The Bluetooth settings menu appears.
2
Rotate the control dial to select
“Device List,” then press the select
button.
The list of registered devices appears.
“Device List,” then press the select
button.
The list of registered devices appears.
3
Select the device to connect.
4
Select “Handsfree Connect.”
“Connection Complete” appears and
connection is complete.
“
“Connection Complete” appears and
connection is complete.
“
” appears during connection.
To stop the connection
Select “Handsfree Disconnect” in step 4.
Deleting the registration of a
connected device
connected device
Select “Delete” in step 4.
Note
While streaming Bluetooth audio, connection noise
may be heard over playback sound.
While streaming Bluetooth audio, connection noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone’s specification. If
this unit does not reconnect automatically, connect
manually.
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone’s specification. If
this unit does not reconnect automatically, connect
manually.
lit:
off:
off:
Bluetooth signal on
Bluetooth signal off
Bluetooth signal off
lit:
flashing:
off:
flashing:
off:
Connection successful
Connecting
No connection
Connecting
No connection
lit:
flashing:
off:
flashing:
off:
Connection successful
Connecting
No connection
Connecting
No connection
Signal strength indication
of the connecting cellular
phone*
of the connecting cellular
phone*
Battery remaining of the
connecting cellular phone*
connecting cellular phone*