3com S7906E Manuel De Montage
1-8
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet
interface view
interface view
interface interface-type
interface-number
interface-number
Enter
Ethernet
interface
view or port
group view
Ethernet
interface
view or port
group view
Enter port
group view
group view
port-group manual
port-group-name
port-group-name
Required
Use either command.
Set the LLDP operating mode
lldp admin-status { disable |
rx | tx | txrx }
rx | tx | txrx }
Optional
TxRx by default.
Setting the LLDP Re-Initialization Delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after a
certain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations caused
by frequent LLDP operating mode changes on a port.
Follow these steps to set the LLDP re-initialization delay for ports:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Set the LLDP re-initialization
delay
delay
lldp timer reinit-delay delay
Optional
2 seconds by default
Enabling LLDP Polling
With LLDP polling enabled, a device checks for local configuration changes periodically. Upon detecting
a configuration change, the device sends LLDP frames to inform the neighboring devices of the change.
Follow these steps to enable LLDP polling:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter
Ethernet
interface view
Ethernet
interface view
interface interface-type
interface-number
interface-number
Enter Ethernet
interface view
or port group
view
interface view
or port group
view
Enter port
group view
group view
port-group manual port-group-name
Required
Use either command.
Enable LLDP polling and set
the polling interval
the polling interval
lldp check-change-interval interval
Required
Disabled by default
Configuring the TLVs to Be Advertised
Follow these steps to configure the LLDPDU TLVs to be advertised out the specified port or ports:
To do…
Use the command…
Remarks
Enter system view
system-view
—