3com S7906E Manuel De Montage

 

1-29 

You may configure the system to attempt setting up a tunnel multiple times until it is established 
successfully or until the number of attempts reaches the upper limit.  

Follow these steps to configure tunnel setup retry:  

Enter system view 

–– 

Enter MPLS TE tunnel interface 
view 

 

 

–– 

Configure maximum number of 
tunnel setup retries 

 times 

Optional 
The default is 5. 

Configure the tunnel setup retry 
interval 

mpls te timer retry seconds

 

Optional 
The default is 2 seconds.  

Submit current tunnel 
configuration 

Required 

 

Two priorities, setup priority and holding priority, are assigned to paths for MPLS TE to make 
preemption decision. For a new path to preempt an existing path, the setup priority of the new path must 
be greater than the holding priority of the existing path.  

To avoid flapping caused by improper preemptions between CR-LSPs, the setup priority of a CR-LSP 
should not be set higher than its holding priority. 

Follow these steps to assign priorities to a tunnel: 

Enter system view 

–– 

Enter MPLS TE tunnel interface 
view 

 

 

–– 

Assign priorities to the tunnel 

mpls te priority setup-priority

 

[ hold-priority ] 

Optional 
The default setup and holding 
priorities are 7. 

Submit current tunnel 
configuration 

Required 

 

Before configuring traffic forwarding, do the following: 

z

 

Configure MPLS basic capabilities  

z

 

Configure MPLS TE basic capabilities 

z

 

Configure MPLS TE tunnels