3com S7906E Manuel De Montage

 

1-2 

z 

Hold timer –– When a GARP application entity receives the first registration request, it starts a hold 

timer and collects succeeding requests. When the timer expires, the entity sends all these requests 

in one Join message. This helps you save bandwidth.  

z 

Join timer –– A GARP participant sends each Join message at most twice for reliability sake and 

uses a join timer to set the sending interval. If the first Join message has not been acknowledged 

before the Join timer expires, the GARP participant sends the second Join message. 

z 

Leave timer –– Starts upon receipt of a Leave message sent for deregistering some attribute 

information. If no Join message has been received before this timer expires, the GARP participant 

removes the attribute information as requested.  

z 

LeaveAll timer –– Starts when a GARP participant starts. When this timer expires, the entity sends 

a LeaveAll message so that other participants can re-register its attribute information. Then, a 

LeaveAll timer starts again.  

 

z 

The settings of GARP timers apply to all GARP applications, such as GVRP, on a LAN.  

z 

Unlike other three timers, which are set on a port basis, the LeaveAll timer is set in system view and 

takes effect globally.  

z 

A GARP participant may send LeaveAll messages at the interval set by its LeaveAll timer or the 

LeaveAll timer on another device on the network, whichever is smaller. This is because each time a 

device on the network receives a LeaveAll message it resets its LeaveAll timer. 

 

The GARP mechanism allows the configuration of a GARP participant to propagate throughout a LAN 

quickly. In GARP, a GARP participant registers or deregisters its attributes with other participants by 

making or withdrawing declarations of attributes and at the same time, based on received declarations 

or withdrawals, handles attributes of other participants. When a port receives an attribute declaration, it 

registers the attribute; when a port receives an attribute withdrawal, it deregisters the attribute.  

GARP participants send protocol data units (PDU) with a particular multicast MAC address as 

destination. Based on this address, a device can identify to which GVRP application (GVRP for example) 

a GARP PDU should be delivered.  

The following figure illustrates the GARP message format.