3com S7906E Manuel De Montage

 

1-10 

Figure 1-4 Network diagram for GVRP configuration 

 

 

1)  Configure Device A 

# Enable GVRP globally.  

<DeviceA> system-view 

[DeviceA] gvrp 

# Configure port GigabitEthernet 2/0/1 as a trunk port, allowing all VLANs to pass through.  

[DeviceA] interface GigabitEthernet 2/0/1 

[DeviceA-GigabitEthernet2/0/1] port link-type trunk 

[DeviceA-GigabitEthernet2/0/1] port trunk permit vlan all 

# Enable GVRP on GigabitEthernet 2/0/1.  

[DeviceA-GigabitEthernet2/0/1] gvrp 

# Set the GVRP registration type to forbidden on the port.  

[DeviceA-GigabitEthernet2/0/1] gvrp registration forbidden 

[DeviceA-GigabitEthernet2/0/1] quit 

# Create VLAN 2 (a static VLAN). 

[DeviceA] vlan 2 

2)  Configure Device B 

# Enable GVRP globally.  

<DeviceB> system-view 

[DeviceB] gvrp 

# Configure port GigabitEthernet 2/0/1 as a trunk port, allowing all VLANs to pass through.  

[DeviceB] interface GigabitEthernet 2/0/1 

[DeviceB-GigabitEthernet2/0/1] port link-type trunk 

[DeviceB-GigabitEthernet2/0/1] port trunk permit vlan all 

# Enable GVRP on GigabitEthernet 2/0/1.  

[DeviceB-GigabitEthernet2/0/1] gvrp 

[DeviceB-GigabitEthernet2/0/1] quit 

# Create VLAN 3 (a static VLAN). 

[DeviceB] vlan 3 

3)  Verify the configuration 

# Display dynamic VLAN information on Device A. 

[DeviceA] display vlan dynamic 

 No dynamic vlans exist! 

# Display dynamic VLAN information on Device B.