3com S7906E Manuel De Montage
1-10
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the remote probe
VLAN
VLAN
mirroring-group group-id
remote-probe vlan
rprobe-vlan-id
remote-probe vlan
rprobe-vlan-id
Required
By default, no remote probe
VLAN is configured for a
mirroring group.
VLAN is configured for a
mirroring group.
z
You are recommended to use the remote probe VLAN for port mirroring exclusively.
z
To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe
VLAN with undo mirroring-group remote-probe vlan command first. Removing the probe VLAN
can invalidate the remote source mirroring group.
Configuring a Remote Destination Mirroring Group (on the Destination Device)
To configure a remote destination mirroring group, make the following configurations on the destination
device:
Creating a remote destination mirroring group
Follow these steps to create a remote destination mirroring group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a remote destination
mirroring group
mirroring group
mirroring-group group-id
remote-destination
remote-destination
Required
By default, no mirroring
group exists on a device.
group exists on a device.
Configuring the monitor port for the remote destination mirroring group
You can configure the monitor port for a mirroring group in system view, or assign the current port to a
mirroring group as the monitor port in interface view. The two modes lead to the same result.
z
Configuring the monitor port in system view
Follow these steps to configure the monitor port for the remote destination mirroring group in system
view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the monitor port
mirroring-group group-id
monitor-port monitor-port-id
monitor-port monitor-port-id
Required
By default, no monitor port is
configured for a mirroring
group.
configured for a mirroring
group.
z
Configuring the monitor port in interface view