3com S7906E Manuel De Montage

 

3-4 

This binding method is applicable to occasions where the registration of invalid ONUs is not taken into 
consideration and the ONUs attached to the OLT are completely trusted. In this way, concern about 
binding is completely ignored. In this case, to remove a binding, disable automatic ONU binding first. 
Otherwise, the removed ONU will be automatically bound again only if goes online.  

Follow these steps to configure batch ONU binding: 

Enter system view 

— 

Enter FTTH view 

 

— 

Configure automatic ONU 
binding 

onu bind auto 

[ slot slot-id ] 

Required 
By default, automatic ONU 
binding is disabled.  

 

Neither batch ONU binding nor automatic ONU binding conflicts with the configuration of binding the 
specified ONU to the specified ONU port. However, batch ONU binding conflicts with automatic ONU 
binding.  

 

To manage an ONU through Telnet, make sure the ONU is assigned an IP address. Only the VLAN 
interface corresponding to the management VLAN can be assigned an IP address. You can designate 
the management VLAN through the command line.  

The management VLAN interface of an ONU can obtain an IP address in one of the following two ways: 

 

Through manual configuration of IP addresses 

 

Through DHCP (with the ONU as a DHCP client) 

Follow these steps to configure the management VLAN of the ONU 

Enter system view 

 

— 

Enter ONU port view  interface onu interface-number

— 

Configuring the 
management VLAN 
of the ONU 

management-vlan vlan-id

 

Optional 
By default, the management VLAN of the 
ONU is VLAN 1.