3com S7906E Manuel De Montage
2-3
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
interface-number
Required
Enable local proxy ARP
local-proxy-arp enable
[ ip-range startIP to endIP ]
[ ip-range startIP to endIP ]
Required
Disabled by default.
Displaying and Maintaining Proxy ARP
To do…
Use the command…
Remarks
Display whether proxy ARP is
enabled
enabled
display proxy-arp [ interface
interface-type interface-number ]
interface-type interface-number ]
Available in any view
Display whether local proxy
ARP is enabled
ARP is enabled
display local-proxy-arp [ interface
interface-type interface-number ]
interface-type interface-number ]
Available in any view
Proxy ARP Configuration Examples
Proxy ARP Configuration Example
Network requirements
As shown in
, Host A and Host D have the same IP prefix and mask (IP addresses of Host A
and Host D are 192.168.10.100/16 and 192.168.20.200/16 respectively), but they are located on
different subnets separated through the switch (Host A belongs to VLAN 1 while Host D belongs to
VLAN 2).
As no default gateway is configured for Host A and Host D, you need to configure proxy ARP on the
switch to enable the communication between the two hosts.
Figure 2-3 Network diagram for proxy ARP