3com S7906E Manuel De Montage

1-12

<SwitchA> system-view

[SwitchA] ipv6

# Configure an IPv4 address for VLAN-interface 100.

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ip address 192.168.100.1 255.255.255.0

[SwitchA-Vlan-interface100] quit

# Configure an IPv6 address for VLAN-interface 101.

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ipv6 address 3002::1 64

[SwitchA-Vlan-interface101] quit

# Configure a manual IPv6 tunnel.

[SwitchA] interface tunnel 0

[SwitchA-Tunnel0] ipv6 address 3001::1/64

[SwitchA-Tunnel0] source vlan-interface 100

[SwitchA-Tunnel0] destination 192.168.50.1

[SwitchA-Tunnel0] tunnel-protocol ipv6-ipv4

[SwitchA-Tunnel0] quit

# Create service loopback group 1 to support the tunnel service.

[SwitchA] service-loopback group 1 type tunnel

# Add GigabitEthernet 2/0/3 to service loopback group 1.

[SwitchA] interface GigabitEthernet 2/0/3

[SwitchA-GigabitEthernet2/0/3] undo stp enable

[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1

[SwitchA-GigabitEthernet2/0/3] quit

# Reference service loopback group 1 on the tunnel.

[SwitchA] interface tunnel 0

[SwitchA-Tunnel0] service-loopback-group 1

[SwitchA-Tunnel0] quit

# Configure a static route to IPv6 Group 2 through tunnel 0 on Switch A.

[SwitchA] ipv6 route-static 3003:: 64 tunnel 0

Configuration on Switch B

# Enable IPv6.

<SwitchB> system-view

[SwitchB] ipv6

# Configure an IPv4 address for VLAN-interface 100.

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ip address 192.168.50.1 255.255.255.0

[SwitchB-Vlan-interface100] quit

# Configure an IPv6 address for VLAN-interface 101.

[SwitchB] interface vlan-interface 101

[SwitchB-Vlan-interface101] ipv6 address 3003::1 64

[SwitchB-Vlan-interface101] quit