3com S7906E Manuel De Montage
1-15
Configuration Procedure
Follow these steps to configure a 6to4 tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6 packet
forwarding function is disabled.
forwarding function is disabled.
Enter tunnel interface view
interface tunnel number
—
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
prefix-length |
ipv6-address/prefix-length }
Configure an
IPv6 global
unicast
address or a
site-local
address
IPv6 global
unicast
address or a
site-local
address
ipv6 address
ipv6-address/prefix-length
eui-64
ipv6-address/prefix-length
eui-64
Required.
Use either command.
By default, no IPv6 global unicast
address or site-local address is
configured for the tunnel interface.
address or site-local address is
configured for the tunnel interface.
ipv6 address auto link-local
Configure
an IPv6
address for
the tunnel
interface
an IPv6
address for
the tunnel
interface
Configure an
IPv6
link-local
address
IPv6
link-local
address
ipv6 address ipv6-address
link-local
link-local
Optional
By default, a link-local address will
automatically be generated when an
IPv6 global unicast address or
site-local address is configured.
automatically be generated when an
IPv6 global unicast address or
site-local address is configured.
Specify the 6to4 tunnel
mode
mode
tunnel-protocol ipv6-ipv4
6to4
6to4
Required
By default, the tunnel is a GRE over
IPv4 tunnel. The same tunnel mode
should be configured at both ends of
the tunnel. Otherwise, packet
delivery will fail.
IPv4 tunnel. The same tunnel mode
should be configured at both ends of
the tunnel. Otherwise, packet
delivery will fail.
Configure a source address
or interface for the tunnel
or interface for the tunnel
source { ip-address |
interface-type
interface-number }
interface-type
interface-number }
Required
By default, no source address or
interface is configured for the tunnel.
interface is configured for the tunnel.