3com S7906E Manuel De Montage
1-19
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms
Configuring an ISATAP Tunnel
Configuration Prerequisites
z
Configure IP addresses for interfaces (such as the VLAN interface, and loopback interface) on the
device to ensure normal communication.
z
Specify one of the above interfaces as the source interface of the tunnel.
z
Ensure reachability between the tunnel source and destination addresses.
Configuration Procedure
Follow these steps to configure an ISATAP tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6 forwarding
function is disabled.
function is disabled.
Enter tunnel interface view interface tunnel number
—
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
prefix-length |
ipv6-address/prefix-length }
Configure an
IPv6 global
unicast
address or
site-local
address
IPv6 global
unicast
address or
site-local
address
ipv6 address
ipv6-address/prefix-length eui-64
ipv6-address/prefix-length eui-64
Required.
Use either command.
By default, no IPv6 global
unicast address is configured for
the tunnel interface.
unicast address is configured for
the tunnel interface.
ipv6 address auto link-local
Configure
an IPv6
address
for the
tunnel
interface
an IPv6
address
for the
tunnel
interface
Configure an
IPv6
link-local
address
IPv6
link-local
address
ipv6 address ipv6-address
link-local
link-local
Optional
By default, a link-local address
will automatically be generated
when an IPv6 global unicast
address or link-local address is
configured.
will automatically be generated
when an IPv6 global unicast
address or link-local address is
configured.
Specify the ISATAP tunnel
mode
mode
tunnel-protocol ipv6-ipv4 isatap
Required
By default, the tunnel is a GRE
over IPv4 tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
over IPv4 tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
Configure a source
address or interface for the
tunnel
address or interface for the
tunnel
source { ip-address |
interface-type interface-number }
interface-type interface-number }
Required
By default, no source address or
interface is configured for the
tunnel.
interface is configured for the
tunnel.