3com S7906E Manuel De Montage

 

1-36 

[SwitchB] ipv6 

# Configure an IPv6 address for VLAN-interface 100. 

[SwitchB] interface vlan-interface 100 

[SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64 

[SwitchB-Vlan-interface100] quit 

# Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel). 

[SwitchB] interface vlan-interface 101 

[SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64 

[SwitchB-Vlan-interface101] quit 

# Create the interface tunnel 2. 

[SwitchB] interface tunnel 2 

# Configure an IPv6 address for the interface tunnel 2. 

[SwitchB-Tunnel2] ipv6 address 3001::1:2 64 

# Configure the tunnel encapsulation mode. 

[SwitchB-Tunnel2] tunnel-protocol ipv6-ipv6 

# Configure the source address for the interface tunnel 2 (IP address of VLAN-interface 101) 

[SwitchB-Tunnel2] source 2002::22:1 

# Configure the destination address for the interface tunnel 2 (IP address of VLAN-interface 101 of 

Switch A). 

[SwitchB-Tunnel2] destination 2002::11:1 

[SwitchB-Tunnel2] quit 

# Create service loopback group 1 to support the tunnel service. 

[SwitchB] service-loopback group 1 type tunnel 

# Add GigabitEthernet 2/0/3 to service loopback group 1. 

[SwitchB] interface GigabitEthernet 2/0/3 

[SwitchB-GigabitEthernet2/0/3] undo stp enable 

[SwitchB-GigabitEthernet2/0/3] port service-loopback group 1 

[SwitchB-GigabitEthernet2/0/3] quit 

# Reference service loopback group 1 on the tunnel. 

[SwitchB] interface tunnel 2 

[SwitchB-Tunnel2] service-loopback-group 1 

[SwitchB-Tunnel2] quit 

# Configure a static route from Switch B through the interface tunnel 2 to Group 1. 

[SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2 

After the above configuration, display the status of the tunnel interfaces on Switch A and Switch B, 

respectively. 

<SwitchA> display ipv6 interface tunnel 1 verbose 

Tunnel1 current state :UP 

Line protocol current state :UP 

IPv6 is enabled, link-local address is FE80::2013:1