3com S7906E Manuel De Montage

 

1-44 

# Configure the destination address of interface Tunnel 0 to be the IP address of interface 

VLAN-interface 101 on Switch B. 

[SwitchA-Tunnel0] destination 2002::2:1 

[SwitchA-Tunnel0] quit 

# Create service loopback group 1, setting the service type to tunnel. 

[SwitchA] service-loopback group 1 type tunnel 

# Add interface GigabitEthernet 2/0/3 to service loopback group 1. 

[SwitchA] interface GigabitEthernet 2/0/3 

[SwitchA-GigabitEthernet2/0/3] undo stp enable 

[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1 

# Apply service loopback group 1 to the tunnel in tunnel interface view. 

[SwitchA-GigabitEthernet2/0/3] quit 

[SwitchA] interface tunnel 0 

[SwitchA-Tunnel0] service-loopback-group 1 

[SwitchA-Tunnel0] quit 

# Configure a static route from Switch A through interface Tunnel 0 to Group 2. 

[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0 

2)  Configure Switch B 

<SwitchB> system-view 

# Enable IPv6. 

[SwitchB] ipv6 

# Configure interface VLAN-interface 100. 

[SwitchB] interface vlan-interface 100 

[SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0 

[SwitchB-Vlan-interface100] quit 

# Configure interface VLAN-interface 101, the physical interface of the tunnel. 

[SwitchB] interface vlan-interface 101 

[SwitchB-Vlan-interface101] ipv6 address 2002::2:1 64 

[SwitchB-Vlan-interface101] quit 

# Create an interface named Tunnel 0. 

[SwitchB] interface tunnel 0 

# Configure an IPv4 address for interface Tunnel 0. 

[SwitchB-Tunnel0] ip address 10.1.2.2 255.255.255.0 

# Configure the tunnel encapsulation mode. 

[SwitchB-Tunnel0] tunnel-protocol gre ipv6 

# Configure the source address of interface Tunnel 0 to be the IP address of interface VLAN-interface 

101. 

[SwitchB-Tunnel0] source 2002::2:1 

# Configure the destination address of interface Tunnel 0 to be the IP address of interface 

VLAN-interface 101 on Switch A. 

[SwitchB-Tunnel0] destination 2002::1:1