3com S7906E Manuel De Montage

 

1-10 

 

You can configure RIP to advertise a default route with a specified metric to RIP neighbors. 

z 

In RIP view, you can configure all the interfaces of the RIP process to advertise a default route; in 

interface view, you can configure a RIP interface of the RIP process to advertise a default route. 

The latter takes precedence over the former on the interface. 

z 

If a RIP process is enabled to advertise a default route, to disable an interface of the RIP process 

from default route advertisement, you can use the rip default-route no-originate command on the 

interface. 

Follow these steps to configure RIP to advertise a default route: 

Enter system view 

–– 

Enter RIP view 

rip [ process-id ] 
[ vpn-instance 
vpn-instance-name ] 

–– 

Enable RIP to advertise a 
default route 

default-route { only | 
originate } [ cost cost ] 

Optional 

Not enabled by default 

Return to system view 

–– 

Enter interface view 

interface interface-type 
interface-number 

–– 

Configure the RIP interface to 
advertise a default route 

rip default-route { { only | 
originate } [ cost cost ] | 
no-originate } 

Optional 

By default, a RIP interface can 
advertise a default route if the 
RIP process is configured with 
default route advertisement. 

 

The router enabled to advertise a default route does not receive default routes from RIP neighbors. 

 

The device supports route filtering. You can filter routes by configuring the inbound and outbound route 

filtering policies by referencing an ACL or IP prefix list. You can also configure the router to receive only 

routes from a specified neighbor. 

Follow these steps to configure route filtering: 

Enter system view 

––