3com S7906E Manuel De Montage

 

1-16 

Enter system view 

–– 

Enter RIP view 

rip [ process-id ] 
[ vpn-instance 
vpn-instance-name ] 

–– 

Specify a RIP neighbor 

peer ip-address 

Required 

Disable source address check 
on incoming RIP updates 

Required 

Not disabled by default 

 

z 

You need not use the peer  ip-address command when the neighbor is directly connected; 

otherwise the neighbor may receive both the unicast and multicast (or broadcast) of the same 

routing information. 

z 

If a specified neighbor is not directly connected, you need to disable source address check on 

incoming updates. 

 

This task allows you to enable a specific RIP process to receive SNMP requests.  

Follow these steps to bind RIP to MIB: 

Enter system view 

–– 

Bind RIP to MIB 

rip mib-binding process-id 

Optional 

By default, MIB is bound to RIP 
process 1. 

 

RIP periodically sends routing information in RIP packets to RIP neighbors.  

Sending large numbers of RIP packets at the same time may affect device performance and consume 

large network bandwidth. To solve this problem, you can specify the maximum number of RIP packets 

that can be sent at the specified interval.  

Follow these steps to configure the RIP packet sending rate: 

Enter system view 

–– 

Enable a RIP process and 
enter RIP view 

rip [ process-id ] 
[ vpn-instance 
vpn-instance-name ] 

––