3com S7906E Manuel De Montage
1-49
To do…
Use the command…
Remarks
Display OSPF ASBR
summarization information
summarization information
display ospf [ process-id ] asbr-summary
[ ip-address { mask | mask-length } ]
[ ip-address { mask | mask-length } ]
Reset OSPF counters
reset ospf [ process-id ] counters [ neighbor
[ interface-type interface-number ]
[ router-id ] ]
[ interface-type interface-number ]
[ router-id ] ]
Reset an OSPF process
reset ospf [ process-id ] process
[ graceful-restart ]
[ graceful-restart ]
Re-enable OSPF route
redistribution
redistribution
reset ospf [ process-id ] redistribution
Available in user
view
view
OSPF Configuration Examples
These examples only cover commands for OSPF configuration.
Configuring OSPF Basic Functions
Network requirements
z
As shown in the following figure, all switches run OSPF. The AS is split into three areas, in which,
Switch A and Switch B act as ABRs to forward routing information between areas.
z
After configuration, all switches can learn routes to every network segment in the AS.
Figure 1-21 Network diagram for OSPF basic configuration
Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configure OSPF basic functions
# Configure Switch A.