3com S7906E Manuel De Montage

 

1-16 

[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic 

[DeviceA-Bridge-Aggregation1] quit 

# Assign Layer 2 Ethernet interfaces GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to 

aggregation group 1.  

[DeviceA] interface gigabitethernet 2/0/1 

[DeviceA-GigabitEthernet2/0/1] port link-aggregation group 1 

[DeviceA-GigabitEthernet2/0/1] quit 

[DeviceA] interface gigabitethernet 2/0/2 

[DeviceA-GigabitEthernet2/0/2] port link-aggregation group 1 

[DeviceA-GigabitEthernet2/0/2] quit 

[DeviceA] interface gigabitethernet 2/0/3 

[DeviceA-GigabitEthernet2/0/3] port link-aggregation group 1 

2)  Configure Device B 

Follow the same configuration procedure performed on Device A to configure Device B. 

As shown in 

 Device A is connection to Device B by their Ethernet ports GigabitEthernet 

2/0/1 through GigabitEthernet 2/0/4.  

Configure the global load sharing mode and aggregation group-specific load sharing mode to enable 

aggregation group 1 to use source MAC-based load sharing mode and aggregation group 2 to use 

destination MAC-based load sharing mode.  

Figure 1-4 Network diagram for Layer 2 aggregation load sharing mode configuration 

GE2

/0/1

GE2

/0/2

GE2

/0/3

GE2

/0/4

G

E

2/0/1

G

E

2/0/2

GE2/0/3

GE2/0/4

 

 

1)  Configure Device A 

# Configure the global link aggregation load sharing mode as the source MAC-based load sharing 

mode.  

<DeviceA> system-view 

[DeviceA] link-aggregation load-sharing mode source-mac 

# Create Layer 2 aggregate interface Bridge-aggregation 1.  

[DeviceA] interface bridge-aggregation 1 

[DeviceA-Bridge-Aggregation1] quit 

# Assign ports GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 to aggregation group 1.