3com S7906E Guide De Référence
1-52
By default, upon receiving an IPv6 IBGP route, the BGP router only checks whether the next hop is
reachable before advertisement. If synchronization is enabled, the IBGP route can be advertised to
EBGP peers only when the route is also advertised by the IGP.
Currently, the system does not support synchronization. Therefore, the configuration of this command
does not actually take effect.
Examples
# Enable the route synchronization between IPv6 BGP and IGP.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] synchronization
timer (IPv6 address family view)
Syntax
timer keepalive keepalive hold holdtime
undo timer
View
IPv6 address family view
Default Level
2: System level
Parameters
keepalive: Keepalive interval in seconds, ranging from 1 to 21845.
holdtime: Holdtime interval in seconds, ranging from 3 to 65535.
Description
Use the timer command to specify IPv6 BGP keepalive interval and holdtime interval.
Use the undo timer command to restore the default.
By default, the keepalive and holdtime intervals are 60s and 180s respectively.
Note that:
z
Timer configured using the peer timer command is preferred to the timer configured using the
timer command.
z
The holdtime interval must be at least three times the keepalive interval.
z
The configured timer applies to all the IPv6 BGP peers. It becomes valid only after the
corresponding IPv6 BGP connections are reset.
Related commands: peer timer.