3com S7906E Guide De Référence

 

1-33 

Use the storm-constrain interval command to set the interval for generating traffic statistics. 

Use the undo storm-constrain interval command to restore the default. 

By default, the interval for generating traffic statistics is 10 seconds. 

 

z 

The interval set by the storm-constrain interval command is specifically for the storm constrain 

function. It is different form that set by the flow-interval command. 

z 

For network stability consideration, configure the interval for generating traffic statistics to a value 

that is not shorter than the default. 

 

# Set the interval for generating traffic statistics to 60 seconds. 

<Sysname> system-view 

[Sysname] storm-constrain interval 60 

unicast-suppression { ratio | pps max-pps } 

undo unicast-suppression 

Layer 2 Ethernet interface view, port group view 

2: System level 

ratio: Maximum percentage of unicast traffic to the total transmission capability of an Ethernet interface, 

in the range of 1 to 100. The smaller the ratio is, the less unicast traffic is allowed through the interface. 

pps max-pps: Specifies the maximum number of unknown unicast packets passing through an Ethernet 

interface per second.  

z 

For a 100-Mbps port, this value ranges from 1 to 148810 (in pps). 

z 

For a 1-Gbps port, this value ranges from 1 to 1488100 (in pps).  

z 

For a 10-Gbps port, this value ranges from 1 to 14881000 (in pps).  

Note that: 

z 

When a suppression granularity larger than 1 is specified on the device, the value of the pps 

keyword should be no smaller than and an integral multiple of the granularity. The broadcast 

suppression threshold value configured through this keyword on an Ethernet interface may not be