3com S7906E Guide De Référence
1-52
Parameters
ttl-value: TTL value of state refresh messages, in the range of 1 to 255.
Description
Use the state-refresh-ttl command to configure the TTL value of state refresh messages.
Use the undo state-refresh-ttl command to restore the system default.
By default, the TTL value of state refresh messages is 255.
Related commands: pim state-refresh-capable, state-refresh-interval, state-refresh-rate-limit.
Examples
# In the public instance configure the device to send PIM state refresh messages with a TTL of 45.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-ttl 45
static-rp (PIM view)
Syntax
static-rp rp-address [ acl-number ] [ preferred ]
undo static-rp rp-address
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level
Parameters
rp-address: IP address of the static RP to be configured. This address must be a legal unicast IP
address, rather than an address on the 127.0.0.0/8 segment.
acl-number: Basic ACL number, in the range of 2000 to 2999. If you provide this argument, the
configured static RP will serve only those groups that pass the ACL filtering; otherwise, the configured
static RP will serve the all-system group 224.0.0.0/4.
preferred: Specifies to give priority to the static RP if the static RP conflicts with the dynamic RP. If you
do not include the preferred keyword in your command, the dynamic RP will be given priority, and the
static RP takes effect only if no dynamic RP exists in the network or when the dynamic RP fails.
Description
Use the static-rp command to configure a static RP.
Use the undo static-rp command to configure a static RP.
By default, no static RP is configured.
Note that:
z
PIM-SM or PIM-DM cannot be enabled on an interface that serves as a static RP.