3com S7906E Guide De Référence

 

1-8 

Aggregation Interface 

Name of the aggregate interface 

Aggregation Mode 

Type of the aggregation group: Static for static 
aggregation, and Dynamic for dynamic 
aggregation.  

System ID 

Local system ID 

Local: 

Port  Status  Priority  Oper-Key  Flag 

Other information of the local end, including the 
member ports, port state, port LACP priority, 
operational key, and LACP protocol state flags. 

Remote: 

Actor  Partner  Priority  Oper-Key SystemID  Flag

Detailed information about the remote end, 
including the corresponding local port, port ID, 
port LACP priority, operational key, system ID, 
and LACP protocol state flags 

 

enable snmp trap updown 

undo enable snmp trap updown 

Layer-2 aggregate interface view 

2: System level 

None 

Use the enable snmp trap updown command to enable linkUp/linkDown trap generation for the 

current aggregate interface.  

Use the undo enable snmp trap updown command to disable linkUp/linkDown trap generation for the 

current aggregate interface.  

By default, linkUp/linkDown trap generation is enabled for an aggregate interface.  

Note that for an aggregate interface to generate linkUp/linkDown traps when its link state changes, you 

must also enable linkUp/linkDown trap generation globally with the snmp-agent trap enable 

[ standard [ linkdown | linkup ] * ] command. 

Refer to SNMP Commands in the System Volume for information about the snmp-agent trap enable 

command.  

# Enable linkUp/linkDown trap generation on interface Bridge-aggregation 1. 

<Sysname> system-view 

[Sysname] snmp-agent trap enable