3com S7906E Guide De Référence
1-17
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the igmp-snooping overflow-replace command to enable the multicast group replacement
function on the current port(s).
Use the undo igmp-snooping overflow-replace command to disable the multicast group replacement
function on the current port(s).
By default, the multicast group replacement function is disabled.
Note that:
z
This command works on both IGMP Snooping–enabled VLANs and VLANs with IGMP enabled on
their VLAN interfaces.
z
Be sure to configure the maximum number of multicast groups allowed on a port which cannot be
the default value 1000 (refer to
) before enabling multicast group
replacement. Otherwise, the multicast group replacement functionality will not take effect.
z
If you do not specify any VLAN when using this command in Ethernet interface view or Layer 2
aggregate interface view, the command will take effect for all VLANs the interface belongs to; if you
specify a VLAN or multiple VLANs, the command will take effect only if the interface belongs to the
specified VLAN(s).
z
If you do not specify any VLAN when using this command in port group view, the command will
take effect on all the ports in this group; if you specify a VLAN or multiple VLANs, the command will
take effect only on those ports in this group that belong to the specified VLAN(s).
Related commands: overflow-replace.
Examples
# Enable the multicast group replacement function on Ethernet 2/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping overflow-replace vlan 2
igmp-snooping querier
Syntax
igmp-snooping querier
undo igmp-snooping querier
View
VLAN view