3com S7906E Guide De Référence

 

1-11 

Layer-2 aggregate interface view 

2: System level 

None 

Use the link-aggregation mode dynamic command to configure an aggregation group to work in 

dynamic aggregation mode.  

Use the undo link-aggregation mode command to restore the default.  

By default, an aggregation group works in static aggregation mode.  

If there is any member port in an aggregation group, you cannot modify the aggregation mode of the 

aggregation group.  

# Configure the aggregation group of Bridge-aggregation 1 to work in dynamic aggregation mode.  

<Sysname> system-view 

[Sysname] interface bridge-aggregation 1 

[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic 

port link-aggregation group number 

undo port link-aggregation group 

Ethernet interface view 

2: System level 

number: Aggregate group number. The value range is 1 to 1,024.  

Use the port link-aggregation group command to assign the current Ethernet interface to the 

specified aggregation group.  

Use the port link-aggregation group command to remove the current Ethernet interface from the 

specified aggregation group.  

Note that: 

z 

If the Ethernet interface is a Layer-2 interface, you must assign it to a Layer-2 aggregation group.