3com S7906E Guide De Référence

 

1-22 

z 

The  source-ip  source-address option in the command is meaningful only for IGMP Snooping 

version 3. If IGMP Snooping version 2 is running, although you can include the source-ip 

source-address option in your command, the configuration will not take effect.  

z 

If configured in Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect 

only if the interface belongs to the specified VLAN. 

z 

If configured in port group view, this feature takes effect only on those ports in this port group that 

belong to the specified VLAN.  

# Configure Ethernet 20/1 in VLAN 2 to be a static member port for (1.1.1.1, 232.1.1.1). 

<Sysname> system-view 

[Sysname] igmp-snooping 

[Sysname-igmp-snooping] quit 

[Sysname] vlan 2 

[Sysname-vlan2] igmp-snooping enable 

[Sysname-vlan2] igmp-snooping version 3 

[Sysname-vlan2] quit 

[Sysname] interface ethernet 2/0/1 

[Sysname-Ethernet2/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1 vlan 2 

igmp-snooping static-router-port vlan vlan-id 

undo igmp-snooping static-router-port vlan vlan-id 

Ethernet interface view, Layer 2 aggregate interface view, port group view 

2: System level 

vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where 

vlan-id is in the range of 1 to 4094.  

Use the igmp-snooping static-router-port command to configure the current port(s) as static router 

port(s).  

Use the undo igmp-snooping static-router-port command to restore the system default.  

By default, no ports are static router ports.  

Note that: 

z 

This command works on both IGMP Snooping–enabled VLANs and VLANs with IGMP enabled on 

their VLAN interfaces.  

z 

This command does not take effect in a sub-VLAN of a multicast VLAN.