3com S7906E Guide De Référence
1-25
Description
Use the max-response-time command to configure the maximum response time to IGMP general
queries globally.
Use the undo max-response-time command to restore the default value.
This command works only on IGMP Snooping–enabled VLANs, but not on VLANs with IGMP enabled
on their VLAN interfaces.
Related commands: igmp-snooping max-response-time, igmp-snooping query-interval.
Examples
# Set the maximum response time to IGMP general queries globally to 5 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] max-response-time 5
overflow-replace (IGMP-Snooping view)
Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
IGMP-Snooping view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the overflow-replace command to enable the multicast group replacement function globally.
Use the undo overflow-replace command to disable the multicast group replacement function
globally.
By default, the multicast group replacement function is disabled.
Note that:
z
This command works on both IGMP Snooping–enabled VLANs and VLANs with IGMP enabled on
their VLAN interfaces.
z
If you do not specify any VLAN, the command will take effect for all VLANs; if you specify a VLAN or
multiple VLANs, the command will take effect for the specified VLAN(s) only.
Related commands: igmp-snooping overflow-replace.