3com S7906E Guide De Référence

 

1-47 

2: System level 

interval: Time to wait before receiving a new refresh message, in seconds and with an effective range of 

1 to 65535.  

Use the state-refresh-rate-limit command to configure the time the router must wait before receiving a 

new state refresh message.  

Use the undo state-refresh-rate-limit command to restore the system default.  

By default, the device waits 30 seconds before receiving a new state refresh message.  

Related commands: pim ipv6 state-refresh-capable, state-refresh-interval, state-refresh-hoplimit. 

# Configure the device to wait 45 seconds before receiving a new state refresh message.  

<Sysname> system-view 

[Sysname] pim ipv6 

[Sysname-pim6] state-refresh-rate-limit 45 

static-rp ipv6-rp-address [ acl6-number ] [ preferred ] 

undo static-rp ipv6-rp-address 

IPv6 PIM view 

2: System level 

ipv6-rp-address: IPv6 address of the static RP to be configured. This address must be a valid, globally 

scoped IPv6 unicast address.  

acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999. If you provide this argument, the 

configured static RP will serve only those IPv6 multicast groups that pass the filtering; otherwise, the 

configured static RP will serve the all IPv6 multicast groups.  

preferred: Specifies to give priority to the static RP if the static RP conflicts with the dynamic RP. If you 

do not include the preferred keyword in your command, the dynamic RP will be given priority, and the 

static RP takes effect only if no dynamic RP exists in the network or when the dynamic RP fails.  

Use the static-rp command to configure a static RP. 

Use the undo static-rp command to configure a static RP.