3com S7906E Guide De Référence

 

1-11 

# Enable fast leave processing on Ethernet 2/0/1 in VLAN 2.  

<Sysname> system-view 

[Sysname] interface ethernet 2/0/1 

[Sysname-Ethernet2/0/1] mld-snooping fast-leave vlan 2 

mld-snooping general-query source-ip { current-interface | ipv6-address } 

VLAN view 

2: System level 

current-interface: Sets the source IPv6 link-local address of MLD general queries to the IPv6 address 

of the current VLAN interface. If the current VLAN interface does not have an IPv6 address, the default 

IPv6 address FE80::02FF:FFFF:FE00:0001 will be used as the source IPv6 address of MLD general 

queries.  

ipv6-address: Specifies the source IPv6 address of MLD general queries, which can be any legal IPv6 

link-local address.  

Use the mld-snooping general-query source-ip command to configure the source IPv6 address of 

MLD general queries.  

Use the undo mld-snooping general-query source-ip command to restore the default configuration.  

By default, the source IPv6 address of MLD general queries is FE80::02FF:FFFF:FE00:0001. 

This command takes effect only if MLD Snooping is enabled in the VLAN.  

# In VLAN 2, specify FE80:0:0:1::1 as the source IPv6 address of MLD general queries.  

<Sysname> system-view 

[Sysname] vlan 2 

[Sysname-vlan2] mld-snooping general-query source-ip fe80:0:0:1::1 

mld-snooping group-limit limit [ vlan vlan-list ] 

undo mld-snooping group-limit [ vlan vlan-list ]