3com S7906E Guide De Référence
1-3
Related commands: multicast ipv6 routing-table in the IPv6 Multicast Routing and Forwarding
Commands in the IP Multicast Volume; mld-snooping enable in the MLD Snooping Commands in the
IP Multicast Volume.
Examples
# Enable MLD Snooping in VLAN 100. Configure it as an IPv6 multicast VLAN and enter IPv6 multicast
VLAN view.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 100
[Sysname-vlan100] mld-snooping enable
[Sysname-vlan100] quit
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100]
port (IPv6 multicast VLAN view)
Syntax
port interface-list
undo port { all | interface-list }
View
IPv6 multicast VLAN view
Default Level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end
interface number must be greater than the start interface number.
all: Deletes all the ports in the current IPv6 multicast VLAN.
Description
Use the port command to assign port(s) to the current IPv6 multicast VLAN.
Use the undo port command to delete port(s) from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
Note that:
z
A port can belong to only one IPv6 multicast VLAN.
z
Only the following types of interfaces can be configured as IPv6 multicast VLAN ports: Ethernet,
and Layer 2 aggregate interfaces.
Examples
# Assign ports GigabitEthernet 2/0/1 through GigabitEthernet 2/0/5 to IPv6 multicast VLAN 100.
<Sysname> system-view