3com S7906E Guide De Référence

 

1-31 

If LDP sessions have been established, you must use the reset mpls ldp command to reset LDP 

sessions for this command to take effect. 

 

# Set the label distribution control mode to independent for the public network LDP instance. 

<Sysname> system-view 

[Sysname] mpls ldp 

[Sysname-mpls-ldp] label-distribution independent 

# Set the label distribution control mode to independent for LDP instance vpn1. 

<Sysname> system-view 

[Sysname] mpls ldp vpn-instance vpn1 

[Sysname-mpls-ldp-vpn-instance-vpn1] label-distribution independent 

MPLS LDP view, MPLS LDP VPN instance view 

1: Monitor level 

None 

Use the loop-detect command to enable loop detection. 

Use the undo loop-detect command to disable loop detection. 

By default, loop detection is disabled. 

Note that you need to enable loop detection before enabling LDP on any interface. 

Related commands: hops-count, path-vectors. 

# Enable loop detection for the public network LDP instance. 

<Sysname> system-view 

[Sysname] mpls ldp 

[Sysname-mpls-ldp] loop-detect 

# Enable loop detection for LDP instance vpn1.