3com S7906E Guide De Référence

 

1-40 

ip-address: IP address for LDP to use as the TCP transport address. 

interface: Specifies that LDP use the IP address of the current interface as the TCP transport address. 

This keyword is available only in interface view. 

Use the mpls ldp transport-address command to configure an LDP transport address. 

Use the undo mpls ldp transport-address command to restore the default. 

By default, a transport address takes the value of the MPLS LSR ID.  

In interface view, you configure the link Hello transport address; in MPLS LDP remote peer view, you 

configure the targeted Hello transport address. 

# On interface VLAN-interface 1, configure the link Hello transport address as the IP address of the 

current interface. 

<Sysname> system-view 

[Sysname] interface vlan-interface 1 

[Sysname-Vlan-interface1] mpls 

[Sysname-Vlan-interface1] mpls ldp 

[Sysname-Vlan-interface1] mpls ldp transport-address interface 

# Configure the targeted Hello transport address to be 10.1.1.1. 

<Sysname> system-view 

[Sysname] mpls ldp remote-peer BJI 

[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3 

[Sysname-mpls-ldp-remote-bji] mpls ldp transport-address 10.1.1.1 

mpls lsr-id lsr-id 

System view 

2: System level 

lsr-id: ID for identifying the LSR, in dotted decimal notation. 

Use the mpls lsr-id command to configure the ID of an LSR.  

Use the undo mpls lsr-id command to remove the ID of an LSR. 

By default, no LSR ID is configured.