3com S7906E Guide De Référence
1-48
<Sysname> system-view
[Sysname] static-lsp transit bj-sh incoming-interface Vlan-interface 2 in-label 123 nexthop
202.34.114.7 out-label 253
statistics interval
Syntax
statistics interval interval-time
undo statistics interval
View
MPLS view
Default Level
2: System level
Parameters
interval-time: Statistics Interval, in the range 30 to 65535 seconds.
Description
Use the statistics interval command to set the statistics interval, that is, the interval for collecting
statistics.
Use the undo statistics interval command to restore the default.
By default, the interval is 0, that is, the system does not collect statistics.
Related commands: display mpls statistics interface, display mpls statistics lsp.
Examples
# Set the statistics interval to 30 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] statistics interval 30
tracert lsp
Syntax
tracert lsp [-a source-ip | -exp exp-value | -h ttl-value | -r reply-mode |-t time-out ] * ipv4 dest-addr
mask-length [ destination-ip-addr-header ]
View
Any view
Default Level
0: Visit level
Parameters
-a source-ip: Specifies the source address for the echo request messages.